If the LIGHT key is pressed for less than 1.5 seconds, the LCD backlight is only switched on for 10 seconds after which, it automatically turns off.Similar Artist: Air, Beck, Bob Dylan, Elton John, Moby, New Order, New York Dolls, Nick Cave & The Bad Seeds, Nirvana, Pink Floyd, Pixies, The Clash, The Kinks, The Smiths, Tom Waits Hhb Portadat Pdr1000 Free Space OnįREE ON DISK Shows the free space on disk BATTERY CHARGE Shows the remaining battery charge or power source. PDR2000 STATUS Shows the PORTADRIVEs current status (i.e. It is a push-lock control that can be pushed to recess it into the front panel to prevent accidental adjustment.īATTERY CHARGE Shows the current battery charge and power source. STOP (lock) This stops playback or recording and also locks (or disables) the panel controls and switches as a safety feature to prevent inadvertently adjusting anything by mistake. In this condition, you can use the PORTADRIVEs front panel without restriction. This is used to show levels, panbalance and other parameters. The four modes are: INPUT When INPUT is pressed, the meters will show input levels 1-8. The PORTADRIVE has three mixers, two of which (BUSMIX and OUTPUT MIX) can be selected here. These options are set in the PORTADRIVEs SETUP mode (more on this later). It is possible to set the peak hold time between OFF, ON or 1-4 seconds. To replace the battery, undo the large thumbscrew and carefully remove the battery. These are: BATTERY COMPARTMENT This is where the LI - ION battery, NP-L50, is housed. The SPDIF input can be assigned to INPUTS 12 and the SPDIF output is sourced from the same signal that is routed to the AESEBU output.ĪES 8-CHANNEL IO D-SUB CONNECTOR This provides 8-channels of AESEBU digital audio input and output and can be used to connect the PORTADRIVE to a digital mixing console or multitrack recorder. The audio at the headphone output can be set to follow whatever is selected for metering ( e.g. HEADPHONE OUTPUT A stereo or 2-mono channel headphone output for private monitoring. When used as a microphone input, each channel has (switchable) phantom power for use with condenser microphones. They are as follows: MICLINE INPUTS These six balanced XLR inputs can accept both microphones and line level signals.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |